hey all...
thought i would quickly post my problem before i go to the repairers.
my honda brushcutter (same as UMK425 but just a few yrs old) keeps playing up, now it has been fully serviced, so all good there.
what happens is, say i start it then use it on a job, then i turn it off when the edges are done, get to the next job, it starts, but as soon as i apply throttle it just dies. if i give everything a dose of wd40 including inside the carbi, it will usually go again. for a while and out of the blu, it just looses power and stops, it's like it is running out of fuel, but it's not.
sometimes it will work fine, i put it away in the shed, next day i go to start it, it starts, than same thing, i apply throttle, and it just dies.
any thoughts?
and Where can I obtain parts related to vehicles? There's a site like this, what do you think: Catalogue AU?
kind regards...La H